FANDOM


File:Bundesarchiv Bild 101I-315-1143-29, Italien, Minen Z42 an Baumstamm.jpg

The Teller mine was a German-made antitank mine common in World War II. With explosives sealed inside a sheet metal casing and fitted with a pressure-actuated fuze, Teller mines had a built-in carrying handle on the side. As the name suggests (Teller is the German word for dish or plate) the mines were plate-shaped. Containing little more than 5.5 kilograms of TNT and a fuze activation pressure of approximately 200 pounds, the Teller mine was capable of blasting the tracks off of any World War II-era tank or destroying a lightly armored vehicle. Because of its rather high operating pressure, only a vehicle or heavy object passing over the Teller mine would set it off.

Of the fuze types available for Tellermines, the T.Mi.Z.43 fuze[1] was notable for featuring an integral anti-handling device as standard: when the fuze is inserted and the pressure plate (or screw cap) is screwed down into place, it shears a weak arming pin inside the fuze with an audible "snap". This action arms the anti-handling device. Thereafter, any attempt to disarm the mine by unscrewing the pressure plate (or screw cap) to remove the fuze will automatically trigger detonation. Since it is impossible to determine which fuze type has been installed, no pressure plate or screw cap should be removed from a Tellermine. The T.Mi.Z.43 fuze may be fitted to the Tellermine 42 and 43 series.

To hinder demining, all Teller mines featured two additional fuze wells (located on the side and underneath) to enable anti-handling devices to be attached.

There were four models of Teller Mine made during World War II:

Approximately 3,622,900 of these mines were produced by Germany from 1943 to 1944.[2]

References Edit

Ad blocker interference detected!


Wikia is a free-to-use site that makes money from advertising. We have a modified experience for viewers using ad blockers

Wikia is not accessible if you’ve made further modifications. Remove the custom ad blocker rule(s) and the page will load as expected.